D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 107

config fdb destination_hit ports
Restrictions
Example usage:
To configure ports 1 to 5 as destination hit ports:
show fdb destination_hit ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the destination hit port status:
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Only administrator-level users can issue this command.
DGS-3324SRi:4#config fdb destination_hit ports 1:1-1:5 enable
Command: config fdb destination_hit ports 1:1-1:5 enable
Success.
DGS-3324SRi:4#
To view the destination hit port status of ports on the Switch.
show fdb destination_hit ports {<portlist>}
This command will allow users to view the destination hit port status
of ports listed in the portlist.
{<portlist>} - Specify a port or ports to be displayed. The port list is
specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
Entering this command without a specified <portlist> will allow the
user to view the destination hit port status of all ports on the Switch.
None.
99