Bootp Relay Commands - D-Link DES-6500 Command Line Interface Reference Manual

The BOOTP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config bootp_relay
config bootp_relay add
config bootp_relay delete
enable bootp_relay
disable bootp_relay
show bootp_relay
Each command is listed, in detail, in the following sections.
config bootp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To configure bootp relay status.
DES-6500:4#config bootp_relay hops 4 time 2
Command: config bootp_relay hops 4 time 2
Success.
DES-6500:4#
config bootp_relay add
Purpose
DES-6500
Parameters
hops <value 1-16>
time <sec 0-65535>
ipif <ipif_name 12>
<ipaddr>
ipif <ipif_name 12>
<ipaddr>
ipif <ipif_name>
Used to configure the BOOTP relay feature of the switch.
config bootp_relay {hops <value>} {time <sec>}
This command is used to configure the BOOTP relay feature.
hops <value> − Specifies the maximum number of relay agent hops that
the BOOTP packets can cross.
time <sec> − If this time is exceeded, the switch will relay the BOOTP
packet.
Only administrator-level users can issue this command.
Used to add an IP destination address to the switch's BOOTP relay
table.
B R
OOTP ELAY
28
C
OMMANDS