D-Link xStack DGS-3324SRi Command Line Interface Reference Manual page 225

show auth_statistics
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current authentication statistics for port 16 of module 1:
DGS-3324SRi:4#show auth_statistics ports 1:16
Command: show auth_statistics ports 1:16
Port number : 1:16
EapolFramesRx
EapolFramesTx
EapolStartFramesRx
EapolReqIdFramesTx
EapolLogoffFramesRx
EapolReqFramesTx
EapolRespIdFramesRx
EapolRespFramesRx
InvalidEapolFramesRx
EapLengthErrorFramesRx
LastEapolFrameVersion
LastEapolFrameSource
CTRL+C ESC q
xStack Gigabit Layer 3 Switch Command Line Interface Manual
Used to display the current authentication statistics.
show auth_statistics {ports <portlist> | all]}
The show auth_statistics command is used to display the
current authentication statistics of the Switch on a per port basis.
ports <portlist> − Specifies a range of ports. The port list is
specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end
of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4 − in numerical order.
all – Specifies that all ports will be viewed.
None.
Quit SPACE n
0
0
0
0
0
0
0
0
0
0
0
00-00-00-00-00-00
Next Page Enter Next Entry
217
a All