Tools Required To Install The Srx5800 Services Gateway; Installing The Srx5800 Services Gateway Mounting Hardware For A Four-Post Rack Or Cabinet - Juniper SRX5800 Hardware Manual

Tools Required to Install the SRX5800 Services Gateway

To install the services gateway, you need the following tools:
Mechanical lift
Phillips (+) screwdrivers, number 2
Electrostatic discharge (ESD) grounding wrist strap
Installing the SRX5800 Services Gateway Mounting Hardware for a
Four-Post Rack or Cabinet
If you are installing the services gateway in a front-mount four-post rack or cabinet, you must first install
the large mounting shelf, followed by the small mounting shelf.
Table 66 on page 213 specifies the holes in which you insert cage nuts and screws to install the mounting
hardware required in a four-post or cabinet rack (an X indicates a mounting hole location). The hole distances
are relative to one of the standard "U" divisions on the rack. The bottom of all mounting shelves is at
0.04 in. (0.02 U) above a "U" division.
Table 66: Four-Post Rack or Cabinet Mounting Hole Locations
Hole Distance Above "U" Division
3 1.51 in. (3.8 cm)
2 0.88 in. (2.2 cm)
1 0.25 in. (0.6 cm)
To install the mounting shelves (see
1. On the front rack rails, install cage nuts in the holes specified in
2. On the front of each front rack rail, partially insert a mounting screw into the hole containing the lowest
cage nut.
3. Install the large shelf on the front rack rails. Rest the bottom slot of each ear on a mounting screw.
4. Partially insert a mounting screw into the top hole in each ear of the large shelf.
0.86 U
0.50 U
0.14 U
Figure 86 on page 214):
Large Shelf Small Shelf
X
X X
X
Table 66 on page 213 for the large shelf.
213