Installing An Srx5800 Services Gateway Network Interface Cable - Juniper SRX5800 Hardware Manual

Press and hold the corresponding online button on the craft interface. The green OK LED next to
the button begins to blink. Hold the button down until the LED goes off.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number offline
For more information about the command, see Junos OS System Basics and Services Command
Reference at www.juniper.net/documentation/.
3. Unplug the cable from the cable connector port. If the network interface uses fiber-optic cable,
immediately cover each transceiver and the end of each cable with a rubber safety cap.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
CAUTION:
are inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Remove the cable from the cable manager and detach it from the destination port.

Installing an SRX5800 Services Gateway Network Interface Cable

Before you begin installing a network interface cable:
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage" on page
Ensure that you have the following available:
ESD grounding strap
To install a fiber-optic cable on a network interface on an IOC, port module, or MIC:
1. Have ready a length of the type of cable used by the component.
2. If the cable connector port is covered by a rubber safety plug, remove the plug.
Do not look directly into a fiber-optic transceiver or into the ends
Do not leave a fiber-optic transceiver uncovered except when you
505.
"Prevention of
394