Juniper SRX5800 Hardware Manual page 346

13. Arrange the cable in the cable manager to prevent it from dislodging or developing stress points. Secure
the cable so that it is not supporting its own weight as it hangs to the floor. Place excess cable out of
the way in a neatly coiled loop. Placing fasteners on the loop helps to maintain its shape.
CAUTION:
allow the fastened loops of a cable to dangle, which stresses the cable at the
fastening point.
CAUTION:
An arc smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
14. Connect the power cables to the chassis.
15. Power on the services gateway.
16. Use one of the following methods to bring the IOC online:
Press and hold the corresponding IOC online button on the craft interface until the green OK LED
next to the button lights steadily, in about 5 seconds.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see Junos OS System Basics and Services Command Reference
at www.juniper.net/documentation/.
You can also verify that the IOC is functioning correctly by issuing the show chassis fpc and
show chassis fpc pic-status commands.
Do not let fiber-optic cables hang free from the connector. Do not
Avoid bending a fiber-optic cable beyond its minimum bend radius.
CAUTION: After the OK LED turns green, wait at least 30 seconds before
removing the IOC again, removing an IOC from a different slot, or inserting
an IOC in a different slot.
347