Removing Cards Before Installing The Srx5800 Services Gateway Chassis - Juniper SRX5800 Hardware Manual

Figure 91: Removing a Lower Fan Tray

Removing Cards Before Installing the SRX5800 Services Gateway Chassis

The services gateway holds up to twelve cards (IOCs, Flex IOCs, MPCs, SCBs, and SPCs), which are installed
horizontally in the front of the device. Each card weighs up to 18.3 lb (8.3 kg), be prepared to accept its
full weight.
To remove a card (see Figure 92 on page
1. Have ready an antistatic mat for the card. Also have ready rubber safety caps for each port using an
optical interface on the card that you are removing.
2. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
3. Label the cables connected to each port on the card so that you can later reconnect the cables to the
correct ports.
223):
221