Juniper SRX5800 Hardware Manual page 421

8. Wait until a message appears on the console confirming that the services have stopped, and then
connect all the disconnected cables.
9. Boot up node 0 by pressing any key on the console.
10. Check the chassis cluster status on node 1:
root@node1>show chassis cluster status
Node 0 comes up and becomes the secondary node on both RG0 and RG1. Wait until the node 0
priority on RG1 changes to the configured value.
11. Verify that sessions are showing up on node 0, and that the number of sessions on node 0 is nearly
equal to the number of sessions on the primary node, node 1:
root@node1>show security monitoring
12. If the cluster is healthy, reset the cluster priorities:
root@node1>request chassis cluster failover reset redundancy-group 1
root@node1>request chassis cluster failover reset redundancy-group 0
422