Juniper SRX5800 Hardware Manual page 271

To install a fan tray (see
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Grasp the fan tray on each side and insert it straight into the chassis. Note the correct orientation by
the "this side up" label on the top surface of the fan tray.
3. Using the Phillips (+) number 2 screwdriver tighten the captive screws on each side of the fan tray
faceplate to secure it in the chassis.
4. Lower the cable manager back into position, if necessary.
Figure 116: Installing an Upper Fan Tray (Standard-Capacity Shown, High-Capacity Similar)
Figure 116 on page 272 and Figure 117 on page 273):
272