Juniper SRX5800 Hardware Manual page 106

Fabric interfaces.
Two Gigabit Ethernet interfaces that allow control information, route information, and statistics to be
sent between the Routing Engine and the CPU on the SPCs.
Two interfaces from the SCBs that enable the boards to be powered on and controlled.
Physical SPC connectors.
Midplane connectors and power circuitry.
Processor subsystem, which includes a 1.2-GHz CPU, system controller, and 1 GB of SDRAM.
LEDs on the faceplate that indicate the SPC and SPU status.
Description SPC with two SPUs
Software release Junos OS Release 9.2 and later
Cables and CHASSIS CLUSTER CONTROL 0 and CHASSIS CLUSTER CONTROL 1–SFP ports for control
connectors links in chassis cluster configurations.
Supported SFP transceivers:
1000BASE-LH (model numbers SRX-SFP-1GE-LH, SRX-SFP-1GE-LH-ET)
1000BASE-LX (model numbers SRX-SFP-1GE-LX, SRX-SFP-1GE-LX-ET)
1000BASE-SX (model numbers SRX-SFP-1GE-SX, SRX-SFP-1GE-SX-ET)
Controls None
Supported Slots SRX5600–Any slot, except the bottom slots 0 or 1 which are reserved for SCB/RE.
SRX5800–Any slot, except the slots 0 or 1 which are reserved for SCB/RE.
Power Maximum 351 W
Requirement
Weight Approximately 13 lb (5.9 kg)
107