Unpacking The Srx5800 Services Gateway - Juniper SRX5800 Hardware Manual

Unpacking the SRX5800 Services Gateway

The services gateway is shipped in a wooden crate. A wooden pallet forms the base of the crate. The
services gateway chassis is bolted to this pallet. A cardboard accessory box and a Getting Started Guide
are also included in the shipping crate.
The shipping container measures 33 in. (83.8 cm) high, 30.25 in. (76.8 cm) wide, and 43.25 in. (109.9 cm)
deep. The total weight of the container containing the services gateway and accessories can range from
270 lb (122.5 kg) to 475 lb (215.5 kg).
NOTE: The services gateway is maximally protected inside the shipping crate. Do not unpack it
until you are ready to begin installation.
To unpack the services gateway, follow these steps (see
1. Move the shipping crate to a staging area as close to the installation site as possible, where you have
enough room to remove the components from the chassis. While the chassis is bolted to the pallet,
you can use a forklift or pallet jack to move it.
2. Position the shipping crate with the arrows pointing up.
3. Open all the latches on the shipping crate.
4. Remove the front door of the shipping crate cover and set it aside.
5. Slide the remainder of the shipping crate cover off the pallet.
6. Remove the foam covering the top of the services gateway.
7. Remove the accessory box and the SRX5800 Services Gateway Getting Started Guide.
8. Verify the parts received as described in
on page 210.
9. Remove the vapor corrosion inhibitor (VCI) packs attached to the pallet, being careful not to break the
VCI packs open.
10. To remove the brackets holding the chassis on the pallet, use a 1/2-in. socket wrench and a number 2
Phillips screwdriver to remove the bolts and screws from the brackets.
Figure 85 on page
"Verifying the SRX5800 Services Gateway Parts Received"
210):
209