Replacing The Srx5800 Services Gateway Air Filter; Removing The Srx5800 Services Gateway Air Filter - Juniper SRX5800 Hardware Manual

CAUTION:
operating. Because the fans are very powerful, they could pull small bits of wire
or other materials into the services gateway through the unfiltered air intake. This
could damage the services gateway components.
The shelf life of polyurethane filter varies from two years to five years depending on the storage
conditions. Store in a cool, dry, and dark environment. Wrap the media in plastic and store in an
environment with relative humidity between 40%- 80% and temperature between 40°F (4° C) to 90°F
(32° C). Note that if the material flakes, or becomes brittle when rubbed or deformed, it is no longer
usable.

Replacing the SRX5800 Services Gateway Air Filter

You should change the air filter every six months. To replace the air filter, perform the following procedures
in sequence:

Removing the SRX5800 Services Gateway Air Filter | 274

1.
Installing the SRX5800 Services Gateway Air Filter | 275
2.
Removing the SRX5800 Services Gateway Air Filter
CAUTION:
air filter in place.
CAUTION:
except during replacement. Because the fans are very powerful, they could pull small
bits of wire or other materials into the services gateway through the unfiltered air
intake. This could damage the services gateway components.
Before you begin to remove the air filter:
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage" on page
Ensure that you have the following available:
Always keep the air filter in place while the services gateway is
Do not run the services gateway for more than two minutes without the
Always keep the air filter in place while the services gateway is operating,
505.
"Prevention of
274