Connecting The Srx5800 Services Gateway To A Network For Out-Of-Band Management - Juniper SRX5800 Hardware Manual

NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Connecting the SRX5800 Services Gateway to a Network for Out-of-Band
Management
To connect the Services Gateway Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45 connectors to the ETHERNET port on the Routing Engine. One Ethernet cable
is provided with the services gateway. To connect to the ETHERNET port on the Routing Engine:
1. Plug one end of the Ethernet cable
port on the Routing Engine.
2. Plug the other end of the cable into the network device.
Figure 101: Routing Engine Ethernet Cable Connector
Figure 102: Ethernet Port
(Figure 101 on page 234
Figure 102 on page 234
shows the connector) into the ETHERNET
shows the port.
234