Installing An Srx5800 Services Gateway Spc - Juniper SRX5800 Hardware Manual

Figure 142: Removing an SPC

Installing an SRX5800 Services Gateway SPC

Before you begin to install a SPC:
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage" on page
Ensure that you have the following available:
ESD grounding strap
Antistatic mat
Rubber safety caps for transceivers
To install an SPC (see Figure 143 on page
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Power off the services gateway using the command request system power-off.
505.
366):
"Prevention of
363