Juniper SRX5800 Hardware Manual page 213

5. Tighten all the screws completely.
6. On the rear rack rails, install cage nuts in the holes specified in
7. On the back of each rear rack rail, partially insert a mounting screw into the hole containing the lowest
cage nut.
8. Install the small shelf on the back rack rails. Rest the bottom slot of each ear on a mounting screw. The
small shelf installs on the back of the rear rails, extending toward the center of the rack. The bottom
of the small shelf should align with the bottom of the large shelf.
9. Partially insert screws into the open holes in the ears of the small shelf.
10. Tighten all the screws completely.
Figure 86: Installing the Mounting Hardware for a Four-Post Rack or Cabinet
Table 66 on page 213 for the small shelf.
214