Installing The Srx5800 Services Gateway Cable Manager - Juniper SRX5800 Hardware Manual

Figure 154: Removing the Cable Manager

Installing the SRX5800 Services Gateway Cable Manager

Before you begin installing the standard cable manager:
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage" on page
Ensure that you have the following available:
ESD grounding strap
7/16 in. (11 mm) nut driver
To install the cable manager (see
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Position the standard cable manager on the studs on the lower front of the chassis.
505.
Figure 155 on page 402):
"Prevention of
401