Connecting Network Cables To Srx5800 Services Gateway Iocs And Port Modules - Juniper SRX5800 Hardware Manual

Figure 104: Connecting an External Alarm-Reporting Device
4. Attach the other end of the wires to the external device.
To attach a reporting device for the other kind of alarm, repeat the procedure.
Connecting Network Cables to SRX5800 Services Gateway IOCs and Port
Modules
To connect the IOCs, MPCs, and port modules to the network (see
1. Have ready a length of the type of cable used by the component.
2. Remove the rubber safety plug from the cable connector port.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
CAUTION:
inserting or removing a cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
Do not look directly into a fiber-optic transceiver or into the ends
Do not leave a fiber-optic transceiver uncovered except when
Figure 105 on page 238):
236