Packing The Srx5800 Services Gateway For Shipment - Juniper SRX5800 Hardware Manual

Packing the SRX5800 Services Gateway for Shipment

To pack the services gateway for shipment:
1. Retrieve the shipping crate and packing materials in which the services gateway was originally shipped.
If you do not have these materials, contact your Juniper Networks representative about approved
packaging materials.
2. On the console or other management device connected to the master Routing Engine, enter CLI
operational mode and issue the following command to shut down the services gateway software.
user@host> request system halt
Wait until a message appears on the console confirming that the operating system has halted.
For more information about the command, see Junos OS System Basics and Services Command Reference
at www.juniper.net/documentation/.
3. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
4. Shut down power to the services gateway by pressing the AC input switch or DC circuit breaker for
all power supplies to the off (O) position.
5. Disconnect power from the services gateway.
6. Remove the cables that connect to all external devices.
7. Remove all field replaceable units (FRUs) from the services gateway.
8. Remove the services gateway chassis from the rack:
If you are using a mechanical lift, place the lift platform under the chassis, unscrew and remove the
mounting screws from the rack, and move the chassis to the shipping crate.
If you are not using a mechanical lift and the chassis weight is fully supported by a shelf or another
device, unscrew and remove the mounting screws from the rack. Three people can then lift the chassis
and move it to the shipping crate.
If you are not using a mechanical lift and the chassis weight is not fully supported by a shelf or another
device, three people should grasp the chassis while a fourth person unscrews and removes the
mounting screws from the rack. The three lifters can then move the chassis to the shipping container.
9. Place the services gateway in the shipping crate or onto the pallet. If on a pallet, bolt the services
gateway to the pallet.
468