Juniper SRX5800 Hardware Manual page 349

ESD grounding strap
Replacement Flex IOC or Flex IOC blank panel
Antistatic mat for the Flex IOC
To remove a Flex IOC (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Use one of the following methods to take the Flex IOC offline:
Press and hold the corresponding online button on the craft interface. The green OK LED next to
the button begins to blink. Hold the button down until the LED goes off.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number offline
For more information about the command, see Junos OS System Basics and Services Command Reference
at www.juniper.net/documentation/.
3. Power off the services gateway using the command request system power-off.
user@host# request system power-off
NOTE: Wait until a message appears on the console confirming that the services stopped.
4. Physically turn off the power and remove the power cables from the chassis.
5. If you have not already done so, remove the port modules installed in the Flex IOC. See
SRX5800 Services Gateway Port Module" on page
6. Simultaneously turn both of the ejector handles counterclockwise to unseat the Flex IOC.
7. Grasp the handles and slide the Flex IOC straight out of the card cage halfway.
8. Place one hand around the front of the Flex IOC and the other hand under it to support it. Slide the
Flex IOC completely out of the chassis, and place it on the antistatic mat or in the electrostatic bag.
Figure 138 on page 352):
355.
350
"Removing an