There is no mounting hole in the center of the chassis that corresponds to the hole in the center of the
bracket.
6. Insert the two screws at the top of the bracket and tighten each partially.
Two screws are needed for mounting the bracket on the center of the chassis. You do not need the
third screw.
7. Tighten the two screws completely.
8. Repeat the procedure for the other bracket.
RELATED DOCUMENTATION
General Safety Guidelines and Warnings | 379
Site Preparation Checklist for the SRX5400 Services Gateway | 147
Installing the SRX5400 Using a Mechanical Lift
IN THIS SECTION
Tools Required to Install the SRX5400 Services Gateway with a Mechanical Lift | 180
Installing the SRX5400 Services Gateway Using a Mechanical Lift | 181
Tools Required to Install the SRX5400 Services Gateway with a Mechanical
Lift
To install the services gateway, you need the following tools:
Mechanical lift
Phillips (+) screwdrivers, number 2
180