Juniper SRX5800 Hardware Manual page 380

Figure 146: Installing a MIC
5. Align the rear of the MIC with the guides located at the corners of the MIC slot.
6. Slide the MIC into the MPC until it is firmly seated in the MPC. The ejector knob will automatically
move in towards the faceplate to lock the MIC in position as it seats.
If the MIC does not seat properly in the slot, pull the ejector knob all the way out and try again to seat
the MIC. The MIC will not seat properly unless the ejector knob is all the way when you start to insert
the MIC.
CAUTION:
components on the MIC.
Slide the MIC straight into the slot to avoid damaging the
381