Juniper SRX5800 Hardware Manual page 386

6. Install each MIC into the appropriate slot on the MPC. See
MIC" on page 379.
7. Locate the slot in the card cage in which you plan to install the MPC.
8. Orient the MPC so that the faceplate faces you.
9. Lift the MPC into place, and carefully align the sides of the MPC with the guides inside the card cage.
See Figure 148 on page
CAUTION:
handles, bus bars, or edge connectors. They cannot support its weight.
Figure 148: Installing an MPC
10. Slide the MPC all the way into the card cage until you feel resistance.
11. Grasp both ejector handles, and rotate them clockwise simultaneously until the MPC is fully seated.
387.
When the MPC is out of the chassis, do not hold it by the ejector
"Installing an SRX5800 Services Gateway
387