Juniper SRX5800 Hardware Manual page 153

You can install Flex IOCs in any of the slots that are not reserved for Switch Control Boards (SCBs). If a
slot is not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling
air to circulate properly through the services gateway.
Figure 74: Flex IOC with Typical Port Modules
Flex IOC
4x10GE-XFP
port module
in slot 0
16x1GE-TX
port module
in slot 1
Description
Software release
Cables and connectors
Controls
Supported Slots
Power Requirement
Weight
LEDs
Flex IOC with slots for two port modules
Maximum throughput: 10 Gbps (per PFE)
Junos OS Release 9.5R1 and later
Slots for two port modules
None
SRX5600–Any slot except bottom slots 0 or 1
SRX5800–Any slot except center slots 0, 1, or 2/6
312 W typical, 365 W maximum (includes port modules)
Approximately 10 lb (4.5 kg)
OK/FAIL LED, one bicolor:
Steady green–The Flex IOC is operating normally.
Red–The Flex IOC has failed and is not operating normally.
Off–The Flex IOC is powered down.
154