Mic With 20X1Ge Sfp Interfaces (Srx-Mic-20Ge-Sfp) - Juniper SRX5800 Hardware Manual

Power requirement
Weight
LEDs
Serial number location

MIC with 20x1GE SFP Interfaces (SRX-MIC-20GE-SFP)

You use Modular Interface Cards (MICs) and Modular Port Concentrators (MPCs) to add different
combinations of Ethernet interfaces to your services gateway to suit the specific needs of your network.
The SRX-MIC-20GE-SFP MIC (see
twenty 1-Gigabit Ethernet small form-factor pluggable (SFP) Ethernet ports.
Maximum of 570 W for the MPC with two MICs, including applicable transceivers.
NOTE:
To install and use SRX5K-MPCs in the SRX5600 and SRX5800 Services Gateways, you
must have high-capacity power supplies (either AC or DC) and high-capacity fan trays
installed in the services gateways. All models of SRX5400 Services Gateways already
include high-capacity supplies. If you do not have high-capacity power supplies and fan
trays installed, the services gateway will log an alarm condition when it recognizes the
SRX5K-MPCs.
On SRX5400 and SRX5600 Services Gateways with AC power supplies, we recommend
that you use high-line (220 V) input power to ensure that the devices have adequate
power to support SRX5K-MPCs.
Approximately 10 lb (4.5 kg) without MICs
OK/FAIL LED, one bicolor:
Green–The MPC is operating normally.
Blinking green–The MPC is transitioning to online or offline.
Red–The MPC has failed and is not operating normally.
Off–The MPC is powered down.
The serial number label is yellow and is located on the opposite side of the card.
Figure 49 on page 121) can be installed in the SRX-5K MPC to add
120