Removing The Cable Manager Before Installing The Srx5800 Services Gateway Chassis - Juniper SRX5800 Hardware Manual

WARNING:
It can contain dangerous voltages.
Figure 88: Removing a Power Supply Before Installing the Services Gateway (Standard-Capacity Power
Supply Shown, High-Capacity Similar)

Removing the Cable Manager Before Installing the SRX5800 Services Gateway Chassis

To remove the cable manager (see
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Using a 7/16-in. nut driver, unscrew the nuts on the corners of the cable manager.
3. Grasp the bottom of the cable manager and pull it straight out from the studs on the front of the chassis.
Do not touch the power connector on the top of the power supply.
Figure 89 on page 219):
218