Replacing Srx5800 Services Gateway Xfp And Sfp Transceivers; Removing An Srx5800 Services Gateway Sfp Or Xfp Transceiver - Juniper SRX5800 Hardware Manual

user@host>request chassis fpc slot slot-number online
For more information about the command, see Junos OS System Basics and Services Command
Reference at www.juniper.net/documentation/.
To bring a port module online:
Press the port module online button until the PIC LED lights green. Use a narrow-ended tool that
fits inside the opening that leads to the button.
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see Junos OS System Basics and Services Command
Reference at www.juniper.net/documentation/.
The normal functioning indicator LED confirms that the component is online. You can also verify correct
IOC functioning by issuing the show chassis fpc command or correct PIC functioning by issuing the
show chassis fpc pic-status command.

Replacing SRX5800 Services Gateway XFP and SFP Transceivers

To replace an XFP or SFP transceiver, perform the following procedures:

Removing an SRX5800 Services Gateway SFP or XFP Transceiver | 396

1.
Installing an SRX5800 Services Gateway SFP or XFP Transceiver | 398
2.
Removing an SRX5800 Services Gateway SFP or XFP Transceiver
Transceivers are installed in a MIC or SPC. Transceivers are hot-insertable and hot-removable. Removing
a transceiver does not interrupt the functioning of the card, but the removed transceiver no longer receives
or transmits data.
Before you begin to remove a SFP or XFP transceiver:
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage" on page
Ensure that you have the following available:
ESD grounding strap
Replacement transceiver or transceiver slot plug
505.
"Prevention of
396