Juniper SRX5800 Hardware Manual page 73

Supported Slots
Power Requirement
Weight
LEDs
Serial Number Location
SRX5400–Only bottom slots 0 and 1/0
SRX5600–Only bottom slots 0 and 1
SRX5800–Only center slots 0, 1, and 2/6
150 W
Approximately 10 lb (4.5 kg)
OK/FAIL LED, one bicolor:
Green–The SCB is operating normally.
Red–The SCB has failed and is not operating normally.
Off–The SCB is powered down.
FABRIC ONLY LED:
Green–The SCB is operating in fabric-only mode.
Off–The SCB is operating in fabric/control board mode.
FABRIC ACTIVE LED:
Green–The fabric is in active mode.
The serial number label is located as shown in
Figure 27: SCB Serial Number Label
Serial number
ID label
Figure 27 on page 74.
74