Srx5800 Services Gateway Craft Interface Power Supply Leds; Srx5800 Services Gateway Craft Interface Card Ok/Fail Leds - Juniper SRX5800 Hardware Manual

Table 6: Host Subsystem LEDs
Label Color
MASTER Green
ONLINE Green
OFFLINE Red

SRX5800 Services Gateway Craft Interface Power Supply LEDs

Each power supply has two LEDs on the craft interface that indicate its status. The LEDs, labeled 0 through
3, are located near the middle of the craft interface next to the PEM label.
the functions of the power supply LEDs on the craft interface.
Table 7: Power Supply LEDs on the Craft Interface
Label Color
PEM Green
Red

SRX5800 Services Gateway Craft Interface Card OK/Fail LEDs

Each slot in the card cage has a pair of LEDs on the craft interface that indicates the status of the card
installed in it. The card LEDs are located along the bottom edge of the craft interface and are labeled as
follows:
0 through 5 on the left
0 and 1 for the two center slots reserved for SCBs
2/6 and 7 through 11 on the right
Table 8 on page 39 describes the functions of the OK and Fail LEDs.
State
On steadily
On steadily
On steadily
Off
State
On steadily
On steadily
Description
Host is functioning as the master.
Host is online and is functioning normally.
Host is installed but the Routing Engine is offline.
Host is not installed.
Table 7 on page 38
Description
Power supply is functioning normally.
Power supply has failed or power input has failed.
38
describes