Juniper SRX5800 Hardware Manual page 134

Figure 59: SRX5K-MPC3-40G10G
If a slot in the SRX5400, SRX5600, or SRX5800 Services Gateway card cage is not occupied by a card,
you must install a blank panel to shield the empty slot and to allow cooling air to circulate properly through
the services gateway.
Description
Software release
Supported Slots
Cables and connectors
Power requirements
Weight
Fixed-configuration MPC with six 40-Gigabit Ethernet ports and twenty-four 10-Gigabit
Ethernet ports
Maximum throughput: 240 Gbps
Maximum configurable MTU: 9192 bytes
Junos OS Release 15.1X49-D10 and later
SRX5400 – Any slot, except the bottom slot 0 which is reserved for SCB/RE.
SRX5600 – Any slot, except the bottom slots 0 or 1 which are reserved for SCB/RE.
SRX5800 – Any slot, except the middle slots 0, 1, and 2/6 which are reserved for SCB/RE
and slots 0 (left most) and 11 (right most).
NOTE: You can use the 2/6 slot to install an interface card if an SCB is not already installed
in it.
Sockets for 40-Gbps and 10-Gbps SFP+ transceivers
See Hardware Compatibility Tool
Typical: 9.68 A @ 48 V (460 W)
At different temperatures:
55° C: 607 W
40° C: 541 W
25° C: 511 W
21 lb (9.52 kg)
for the transceivers supported.
135