Juniper SRX5800 Hardware Manual page 236

3. Insert the cable connector into the cable connector port on the faceplate.
NOTE: The XFP cages and optics on the components are industry standard parts that
have limited tactile feedback for insertion of optics and fiber. You need to insert the optics
and fiber firmly until the latch is securely in place.
4. Arrange the cable in the standard or extended cable manager to prevent it from dislodging or developing
stress points. Secure the cable so that it is not supporting its own weight as it hangs to the floor. Place
excess cable out of the way in a neatly coiled loop. Placing fasteners on the loop helps to maintain its
shape.
CAUTION:
An arc smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
CAUTION:
allow the fastened loops of a cable to dangle, which stresses the cable at the
fastening point.
Avoid bending a fiber-optic cable beyond its minimum bend radius.
Do not let fiber-optic cables hang free from the connector. Do not
237