Juniper SRX5800 Hardware Manual page 436

Table 69: Chassis Component Alarm Conditions on SRX5400, SRX5600, and SRX5800 Services
Gateways (continued)
Chassis
Component Alarm Condition
Routing Engine Excessive framing errors on
console port.
An excessive framing error
alarm is triggered when the
default framing error
threshold of 20 errors per
second on a serial port is
exceeded.
This might be caused by a
faulty serial console port
cable connected to the
device.
Error in reading or writing
hard disk.
Error in reading or writing
CompactFlash card.
System booted from default
backup Routing Engine. If
you manually switched
mastership, ignore this
alarm condition.
System booted from hard
disk.
CompactFlash card missing
in boot list.
Remedy
Replace the serial cable
connected to the device.
If the cable is replaced and
no excessive framing
errors are detected within
5 minutes from the last
detected framing error, the
alarm is cleared
automatically.
Reformat hard disk and
install bootable image. If
this fails, replace failed
Routing Engine.
Reformat CompactFlash
card and install bootable
image. If this fails, replace
failed Routing Engine.
Install bootable image on
default master Routing
Engine. If this fails, replace
failed Routing Engine.
Install bootable image on
CompactFlash card. If this
fails, replace failed Routing
Engine.
Replace failed Routing
Engine.
Alarm
Severity
Yellow
Yellow
Yellow
Yellow
Yellow
Red
Red
437