Removing The Srx5800 Services Gateway Cable Manager - Juniper SRX5800 Hardware Manual

Removing the SRX5800 Services Gateway Cable Manager

Before you begin to remove cable manager:
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage" on page
Ensure that you have the following available:
ESD grounding strap
7/16 in. (11 mm) nut driver
To remove the cable manager (see
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Using a 7/16-in. nut driver, unscrew the nuts on the corners of the cable manager.
3. Grasp the bottom of the cable manager and pull it straight out from the studs on the front of the chassis.
505.
Figure 154 on page 401):
"Prevention of
400