Juniper SRX5800 Hardware Manual page 239

6. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
7. Place the grounding cable lug over one of the two grounding points. The right pair is sized for UNC
1/4-20 screws and 1/4 in. split washers, which are provided in the accessory box. The left pair is sized
for M6 metric screws. If you wish to use the metric-sized grounding point, you must provide appropriate
screws and split washers.
8. Secure the grounding cable lug to the grounding point, first with the washers, and then with the screws
as shown in Figure 106 on page
Figure 106: Connecting the Grounding Cable
M6 (Metric)
Grounding Point
9. Dress the grounding cable and verify that it does not touch or block access to services gateway
components, and that it does not drape where people could trip on it.
240.
1/4-20 Grounding Point
240