Juniper SRX5800 Hardware Manual page 140

Figure 63: SRX5K-IOC4-10G
SRX5K-IOC4-10G
If a slot in the SRX5400, SRX5600, or SRX5800 Services Gateway card cage is not occupied by a card,
you must install a blank panel to shield the empty slot and to allow cooling air to circulate properly through
the services gateway.
Description
Software release
Supported slots
Cables and connectors
Power requirements
Weight
Fixed-configuration IOC with forty 10-Gbps port speeds
Maximum throughput: 400-Gbps
Maximum configurable MTU: 9192 bytes
Junos OS Release 19.3R1 and later
SRX5400—Any slot, except the bottom slots 0 and 1/0,
which are reserved for SCB/RE.
NOTE: Slot 1/0 is a dual purpose slot. You can install
SRX5K-IOC4-10G in slot 2/6 if an SCB is not already
installed in it.
SRX5600—Any slot, except the bottom slots 0 and 1,
which are reserved for SCB/RE.
SRX5800—Any slot, except the middle slots 0, 1, and
2/6, which are reserved for SCB/RE, and slots 0 (most
left) and 11 (most right).
NOTE: Slot 2/6 is a dual purpose slot. You can install
SRX5K-IOC4-10G in slot 2/6 if an SCB is not already
installed in it.
See Hardware Compatibility Tool
supported.
Typical: 405 W
At different temperatures:
131° F (55° C): 500 W
104° F (40° C): 465 W
75° F (25° C): 430 W
17 lb (7.7 kg)
for the transceivers
141