Replacing A Routing Engine: External Scp Server Method - Juniper SRX5800 Hardware Manual

root@node1> show chassis cluster status
Node 0 comes up and becomes the secondary node on both RG0 and RG1. Wait until the node 0
priority on RG1 changes to the configured value.
11. Verify that sessions are showing up on node 0, and that the number of sessions on node 0 is nearly
equal to the number of sessions on the primary node, node 1:
root@node1> show security monitoring
12. If the cluster is healthy, reset the cluster priorities:
root@node1> request chassis cluster failover reset redundancy-group 1
root@node1> request chassis cluster failover reset redundancy-group 0

Replacing a Routing Engine: External SCP Server Method

The following are the assumptions and prerequisites for this procedure:
Console access and SSH access are available.
The chassis cluster has only two redundancy groups (RG0 and RG1) configured.
This procedure includes the steps for replacing the Routing Engine on node 0 of a chassis cluster setup.
You can follow the same steps to replace the Routing Engine on node 1.
410