Srx5800 Services Gateway Spc Description; Services Processing Card Srx5K-Spc-2-10-40 Specifications - Juniper SRX5800 Hardware Manual

105

SRX5800 Services Gateway SPC Description

The Services Processing Card (SPC) has Services Processing Units (SPUs), which provide the processing
power to run integrated services such as firewall, IPsec, and IDP (see Figure 42 on page 105). All traffic
traversing the services gateway is passed to an SPU to have services processing applied to it. Traffic is
intelligently distributed by interface cards to SPUs for services processing.
The services gateway must have one SPC installed.
You can install an SPC in any of the slots that are not reserved for Switch Control Board (SCB). If a slot is
not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to
circulate properly through the device.
Figure 42 on page 105 shows a typical SPC supported on the services gateway.
Figure 42: Typical SPC
For detailed information about SPCs supported by the services gateway, see the SRX5400, SRX5600, and
SRX5800 Services Gateway Card Reference at www.juniper.net/documentation/.

Services Processing Card SRX5K-SPC-2-10-40 Specifications

The SRX5K-SPC-2-10-40 Services Processing Card (SPC) contains two Services Processing Units (SPUs),
which provide the processing power to run integrated services such as firewall, IPsec, and IDP (see