Replacing An Srx5800 Services Gateway Ac Power Supply; Removing An Srx5800 Services Gateway Ac Power Supply - Juniper SRX5800 Hardware Manual

Replacing an SRX5800 Services Gateway AC Power Supply

To replace an AC power supply, perform the following procedures:

Removing an SRX5800 Services Gateway AC Power Supply | 278

1.
Installing an SRX5800 Services Gateway AC Power Supply | 281
2.
Removing an SRX5800 Services Gateway AC Power Supply
Before you remove a power supply, be aware of the following:
NOTE: The minimum number of power supplies must be present in the services gateway at all
times.
CAUTION:
power supply unit, each power supply slot must contain either a power supply or a
blank panel. If you remove a power supply, you must install a replacement power
supply or a blank panel shortly after the removal.
NOTE: After powering off a power supply, wait at least 60 seconds before turning it back on.
Before you begin to remove the AC power supply:
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage" on page
Ensure that you have the following available:
To maintain proper cooling and prevent thermal shutdown of the operating
505.
"Prevention of
278