Maintaining The Srx5800 Power System - Juniper SRX5800 Hardware Manual

ESD grounding strap
To install the air filter (see
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Ensure the air filter is right side up.
3. Place the air filter into the air filter tray.
4. Insert the air filter tray into the chassis by sliding it straight into the chassis until it stops.
5. Lower the cable manager back into position.
6. Rearrange the cables in the cable manager.
Figure 119: Installing the Air Filter Standard-Capacity Filter Tray Shown, High-Capacity Similar)

Maintaining the SRX5800 Power System

IN THIS SECTION
Maintaining SRX5800 Services Gateway Power Supplies | 277
Replacing an SRX5800 Services Gateway AC Power Supply | 278
Replacing an SRX5800 Services Gateway AC Power Supply Cord | 284
Replacing an SRX5800 Services Gateway DC Power Supply | 287
Replacing an SRX5800 Services Gateway DC Power Supply Cable | 296
Upgrading an SRX5800 Services Gateway from Standard-Capacity to High-Capacity Power Supplies | 300
Figure 119 on page 276):
276