Installing The Srx5800 Services Gateway Craft Interface - Juniper SRX5800 Hardware Manual

To remove the craft interface (see
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Detach any external devices connected to the craft interface.
3. Using the Phillips (+) number 2 screwdriver loosen the captive screws at the left and right corners of
the craft interface faceplate.
4. Grasp the craft interface faceplate and carefully tilt it toward you until it is horizontal.
5. Disconnect the ribbon cable from the back of the faceplate by gently pressing on both sides of the
latch with your thumb and forefinger. Remove the craft interface from the chassis.
Figure 111: Removing the Craft Interface

Installing the SRX5800 Services Gateway Craft Interface

Before you begin installing the craft interface into the services gateway:
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See
Electrostatic Discharge Damage" on page
Ensure that you have the following available:
ESD grounding strap
Phillips (+) number 2 screwdriver
Figure 111 on page 265):
505.
"Prevention of
265