Removing Fan Trays Before Installing The Srx5800 Services Gateway Chassis - Juniper SRX5800 Hardware Manual

219
Figure 89: Removing the Cable Manager

Removing Fan Trays Before Installing the SRX5800 Services Gateway Chassis

To remove the upper or lower fan tray (see Figure 90 on page 220 and Figure 91 on page 221, which illustrate
the upper and lower fan trays):
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Loosen the captive screw on each side of the fan tray faceplate.
3. Grasp both sides of the fan tray and pull it out approximately 1 to 3 inches.
4. Press on the two latches located on the inside of the fan tray to release the fan tray from the chassis.
5. Place one hand under the fan tray to support it and pull the fan tray completely out of the chassis.