Installing A Cable On An Mx240 Dpc, Mpc, Mic, Or Pic - Juniper MX240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide

Installing a Cable on an MX240 DPC, MPC, MIC, or PIC

254
To install a cable on a DPC, MPC, MIC, or PIC:
Have ready a length of the type of cable used by the component. For cable
1.
specifications, see the
MX Series Interface Module Reference
If the cable connector port is covered by a rubber safety plug, remove the plug.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
you are inserting or removing cable. The safety cap keeps the port clean
and prevents accidental exposure to laser light.
Insert the cable connector into the cable connector port on the faceplate.
3.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
Insert the other end of the cable into the destination port.
4.
Repeat the previous steps for any additional cables.
5.
If the component is offline (its failure indicator LED is lit), use one of the following
6.
methods to bring the PIC online:
To bring a DPC or an MPC online:
Press and hold the corresponding online button on the craft interface until the
green LED next to the button lights steadily, in about 5 seconds.
OK
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
.
Copyright © 2017, Juniper Networks, Inc.