Toyota Avensis ZZT251 2003 Service And Repair Manual page 1505

65–6
2
5
2
1
Standard:
Tester connection
1 – body ground
1 – body ground
10 – body ground
24 – body ground
AVENSIS REPAIR MANUAL (RM1018E)
LIGHTING
2.
LH:
3
(a)
(b)
1
RH:
2
3
(c)
1
(d)
(e)
E68999
3.
(a)
E68130
Condition
Turn ignition switch ON
Turn ignition switch OFF
Headlamp switch is HEAD
http://vnx.su
– LIGHTING SYSTEM
INSPECT HEADLAMP ASSEMBLY (HEADLIGHT
BEAM LEVEL CONTROL ACTUATOR OPERATION)
Disconnect the connector from the headlamp assy.
Connect the positive (+) lead from the battery to the termi-
nal 3 of each of the headlight beam level control actuator
and negative (–) lead from the battery to the terminal 1 of
the each of the headlight beam level control actuator.
Connect the positive (+) lead from the battery to the termi-
nal 1 of headlamp levering switch and negative (–) lead
from the battery to the terminal 5 of the headlamp levering
switch.
Connect the terminal 2 of the headlamp leveling switch
and the terminal 2 of the each of headlight beam level
control actuator.
Measure voltage between the terminal 2 of the headlamp
leveling switch and the battery negative (–) terminal when
headlamp levering switch is operated.
Standard:
Switch position
0
1
2
3
4
5
HEADLAMP LEVELING ECU ASSY
Measure voltage between the terminal as shown in the
chart below.
Always
Specified condition (V)
8.5 to 11.8
7.4 to 10.3
6.3 to 8.8
5.2 to 7.3
4.1 to 5.8
3.0 to 4.3
Specified condition
10 to 14 V
No voltage
Below 1 V
Continuity