Table of Contents
Advertisement
AVENSIS REPAIR MANUAL (RM1018E)
LIGHTING
–
HEADLAMP UNIT LH
(b)
Release the lock of the set spring and remove the dis-
charge headlamp bulb.
I35255
7.
REMOVE HEADLAMP, NO.2 BULB
(a)
Remove the headlamp socket cover.
(b)
Release the lock of the set spring and remove the head-
lamp bulb No.2.
I35244
8.
REMOVE CLEARANCE LAMP BULB
(a)
Remove the clearance lamp socket and the clearance
lamp bulb as shown in the illustration.
(b)
Remove the clearance lamp bulb from the clearance lamp
socket.
I35229
9.
REMOVE FRONT TURN SIGNAL LAMP BULB
(a)
Remove the front turn signal lamp socket and the front
turn signal lamp bulb as shown in the illustration.
10.
REMOVE HEADLAMP PROTECTOR RETAINER
HINT:
When only the installation part of the headlamp unit assy LH is
damaged, it can be repaired inexpensively by using a head-
lamp protector retainer. In this case, however, the headlamp
unit assy LH itself should not be damaged.
I35245
(a)
Cut off the part shaded in the illustration and file it smooth.
NOTICE:
After cutting off the part roughly, place the headlamp pro-
tector retainer against the bosses, and gradually file any in-
terfering part until the proper condition for installation is
made.
I36703
http://vnx.su
65–17
Advertisement
Table of Contents
