Avaya WLAN 8100 Series Reference page 71

11. Use the following command to view current DiffServ configuration.
AP Client QoS configuration attributes
Use the following attributes to configure AP Client QoS.
Match All
Protocol
Source IP Address
Source IP Mask
Avaya WLAN 8100 CLI Reference
Diffserv Policy Name:
WC8180#
WC8180#show running-config module wireless diffserv
Criteria
Specifies that a packet must match all criteria of the classifier
block.
Allow
ACL and Rule and will be either permitted or denied.
The
Match All
Specifies the packet's protocol as the match condition for the
selected rule.
The protocol is identified by a number. This number is a
standard value assigned by IANA and is an integer in the
range
Specifies the packet's source port IP address as the match
condition for the rule.
The address you enter is compared with the packet's source
IP Address. You must also specify a source IP Mask with the
Source IP Address.
Specifies the source IP address wildcard mask.
The wild card masks determines which bits are used and
which bits are ignored. A wild card mask of
255.255.255.255
wildcard of
important.
Wildcard masking for ACLs operate differently from a subnet
mask. A wildcard mask is in fact the inverse of a subnet mask.
With a subnet mask, the mask has ones (
positions that are used for the network address, and has
zeros (
a wildcard mask has a
checked and a
This field is required when you configure a source IP
address.
ACLI reference for the Wireless LAN (WLAN) 8100
None
Description
signifies that all packets will match the selected IP
Match All rule overrides all other filtering rules, so if
is set, the other rules are not configurable.
1 to 255 .
indicates that no bit is important. A
0.0.0.0 indicates that all of the bits are
0 ) for the bit positions that are not used. In contrast,
0
in the bit position that must be
1 in the bit position that can be ignored.
Note:
None
1 ) in the bit
August 2013 71