Avaya WLAN 8100 Series Reference page 363

2. Enter the show interfaces [port list] verbose command. If you issue
3. Observe the CLI output.
Validating port operational status
About this task
VLACP: Configure VLACP on port 1 from a 8100 series unit and on port 2 on 5000 series unit.
Have a link between these 2 ports. When the show interfaces command is typed, VLACP
status is up for port on the unit where the command is typed. Pull out the link from the other
switch, VLACP status goes Down.
STP: After switch boots, type show interfaces command. STP Status is Listening (wait a
few seconds and try again). STP Status becomes Learning.
After a while (15 seconds is the forward delay default value, only if you did not configure another
time interval for STP forward delay), if you type show interfaces again, STP Status should
be forwarding.
Showing port information
About this task
Perform this procedure to display port configuration information.
Avaya WLAN 8100 CLI Reference
the command with no parameters the port status is shown for all ports.
ACLI reference for wired networks
August 2013 363