Avaya WLAN 8100 Series Reference page 350

ACLI Reference for wired networks
Configuring DAPP status tracking
About this task
This procedure describes how to configure DAPP status tracking.
Note: If adequate resources are not available to enable this feature the command will fail.
Procedure
Enable DAPP status tracking by using the following command from Global
Configuration mode:
qos agent dos-attack-prevention status-tracking [enable | max-
ipv4-icmp | max-ipv6-icmp | min-tcp-header]
About this task
This procedure describes how to set the maximum IPv6 ICMP length used by DAPP.
Procedure
Set the maximum IPv6 ICMP length by using the following command from Global
Configuration mode:
qos agent dos-attack-prevention max-ipv6-icmp <0-16383>
Configuring DAPP minimum TCP header size
About this task
This procedure describes how to set the minimum TCP header size used by DAPP.
Procedure
Set the minimum TCP header size by using the following command from Global
Configuration mode:
qos agent dos-attack-prevention min-tcp-header <0-255>
Configuring DAPP maximum IPv4 ICMP length
About this task
This procedure describes how to set the maximum IPv4 ICMP length used by DAPP.
Procedure
Set the maximum IPv4 ICMP length by using the following command from Global
Configuration mode:
qos agent dos-attack-prevention max-ipv4-icmp <0-1023>
350 Avaya WLAN 8100 CLI Reference
Configuring DAPP maximum IPv6 ICMP length
Comments? infodev@avaya.com
August 2013