Configuring IGMP proxy on a VLAN
About this task
Use this procedure to enable IGMP proxy on a snoop-enabled VLAN. With IGMP proxy
enabled, the switch consolidates incoming report messages into one proxy report for that
group.
IGMP proxy is disabled by default.
Prerequisites
• You must enable snoop on the VLAN.
Procedure
To enable IGMP proxy, enter the following from the VLAN Interface Configuration
mode:
[default] [no] ip igmp proxy
OR
Enter the following from the Global Configuration command mode:
[default] [no] vlan igmp <vid> [proxy {enable | disable}]
default
no
<vid>
enable
disable
Configuring the IGMP version on a VLAN
About this task
Use this procedure to configure the IGMP version running on the VLAN. You can specify the
version as IGMPv1, IGMPv2, or IGMPv3 (IGMPv3 is supported for IGMP snooping only; it is
not supported with PIM-SM). The default is IGMPv2.
Procedure
To configure the IGMP version, enter the following from the VLAN Interface
Configuration mode:
[default] ip igmp version <1-3>
Avaya WLAN 8100 CLI Reference
Variable Definitions
Variable
Disables IGMP proxy on the selected VLAN.
Disables IGMP proxy on the selected VLAN.
Specifies the VLAN ID.
Enables IGMP proxy on the selected VLAN.
Disables IGMP proxy on the selected VLAN.
ACLI reference for wired networks
Value
August 2013
293