Configuring Wired Quality Of Service - Avaya WLAN 8100 Series Reference

ACLI Reference for wired networks
Variable
name <WORD>
set-id <1-55000>
set-name <WORD>
in-profile-action
<1-55000>
in-profile-action-name
<WORD>
meter <1-55000>
meter-name <WORD>
Removing classifier block entries
About this task
Use the following procedure to delete classifier block entries.
Procedure
Delete classifier block entries by using the following command from Global
Configuration mode.
no qos classifier-block <1-55000>

Configuring wired Quality of Service

About this task
The following sections describe the CLI commands to configure DiffServ and Quality of Service
(QoS) parameters for policy-enabled networks.
Note:
When the ignore value is used in QoS, the system matches all values for that parameter.
Related topics:
Displaying QoS Parameters
Displaying QoS capability policy configuration
316 Avaya WLAN 8100 CLI Reference
Specifies the label for the classifier block; maximum is 16
alphanumeric characters.
Specifies the classifier set to be linked to the classifier block;
range is 1–55000.
Specifies the classifier set name to be linked to the classifier
block; maximum is 16 alphanumeric characters.
Specifies the in profile action to be linked to the filter block;
range is 1–55000.
Specifies the in profile action name to be linked to the classifier
block; maximum is 16 alphanumeric characters.
Specifies the meter to be linked to the classifier block; range
is 1–55000.
Specifies the meter name to be linked to the classifier block;
maximum is 16 alphanumeric characters.
on page 317
on page 321
Comments? infodev@avaya.com
Value
August 2013