Avaya WLAN 8100 Series Reference page 267

Procedure
To configure the port mode, use the following command from Interface Configuration
mode.
lacp port-mode {default | advance}
Variable Definitions
default
advance
Configuring VLACP using CLI
Use the following commands to configure VLACP using the CLI.
Related topics:
Enabling VLACP globally
Configuring VLACP multicast MAC address
Displaying VLACP status
Displaying VLACP port configuration
About this task
Use the following procedure to globally enable VLACP for the device.
Procedure
To enable VLACP, use the following command from Global Configuration mode.
[no] vlacp enable
Use the no form of this command to disable.
Configuring VLACP port parameters
About this task
Use the following procedure to configure VLACP parameters on a port.
Procedure
To configure parameters, use the following command from Interface Configuration
mode.
[no] vlacp port <port> [enable | disable] [timeout <long/
short>][fast-periodic-time <integer>] [slow-periodic-time
<integer>] [timeout-scale <integer>] [funcmac-addr <mac>]
[ethertype <hex>]
Avaya WLAN 8100 CLI Reference
Variable
on page 267
on page 270
Enabling VLACP globally
Value
Default LACP port mode.
Advanced LACP port mode.
on page 269
on page 270
ACLI reference for wired networks
August 2013 267