Avaya WLAN 8100 Series Reference page 24

ACLI reference for Wireless LAN (WLAN) 8100
• promisc-mode + include-data — you see data to/from all APs.
• promisc-mode + no frame-types — you do not see any packets.
• promisc-mode + include-data + include-beacon + include-probe — you see data, beacon
and probes from all APs.
• no promisc-mode + include-data + include-beacon + include-probe — you see beacons
and probes from all APs, but data only from your AP.
CLI commands reference for remote packet capture
Commands to configure a capture profile
Use the following parameters to define a capture profile on a managed Access Point (AP).
Command
default
direction
duration
end
exit
filters
24 Avaya WLAN 8100 CLI Reference
Parameters
none Sets the command to its default values.
Specifies the capture flow direction.
The direction is specified with respect to the MU.
Uplink
By default, both directions are enabled. Uplink
indicates
indicates
both Specifies both transmit and receive.
downlink Specifies transmit only.
uplink Specifies receive only.
<0–86400> Range is 0 to 86400 seconds.
Specifies the duration for which capture should
continue. Packet capture stops after the time
duration elapses. Use a default value of 5
minutes. A value of 0 means infinite duration.
End wireless capture configuration mode.
Exit from wireless capture configuration mode.
client-mac Traffic is captured only from/to specific client
MAC address. To exclude this filter, set the
value to empty string.
This setting is ignored on promiscuous mode.
This filter is not applicable to beacons.
By default, the client MAC address is
include-beacons Include 802.11 beacons frames from captures
on radio interfaces. This filter is disabled by
default. When a station MAC filter is set, it is not
applied for selection of beacon frames
Comments? infodev@avaya.com
Description
and Downlink are valid directions.
receive for an AP and downlink
transmit for the AP.
null .
August 2013